Gå til hovedindhold
UdbudsScanner
Alle udbud
TED301627-2025

NEA and SLF02 – Procurement of 400 kV and 132 kV cable systems

Ordregiver
Energinet Eltransmission A/S
Oplyst værdi / estimat
42.550.000 EUR
Frist
—
Publiceret
13.5.2025
CPV
31321300, 31300000, 31320000, 31340000, 31343000
Leveringssted (NUTS)
DNK

Dataposten opdateret . Datakilder, dækning og beregningsmetode.

Beskrivelse
The Contracting Authority wants to purchase delivery of approximately 490 km 400 kV single core cable XLPE-insulated land cable and 15 km 132 kV single core XLPE-insulated land cable, joints and terminations and installation of joints and terminations. The deliverables are divided into three lots: Lot 1 – NEA, Lot 2 - NEA and Lot 3 – SLF02. The scope of the three tendered lots are described in detail in the enclosed tender documents. For further detail regarding the purchase, reference is made to the tender documents. However please note the following: The Contracting Authority will also accept solutions with a welded aluminum sheath. In case a welded aluminum sheath is offered, the sheath is allowed to carry the full fault current without the support of a wire screen. For further information see the technical requirements c.f. doc. no. 24/13859-18. It is possible to apply for prequalification for one, two or all three lots. The application should clearly state for which lot it concerns. Subsequent tenders may be submitted for Lots the tenderer is prequalified for. If an applicant applies for prequalification for all three Lots, but does not have the capacity for all, this must be clearly stated in the application. Please note that it is not possible to include a discount for being awarded more than one lot. If the same tenderer is evaluated with the highest score for more than one lot the tenderer will be awarded more than one lot provided the tenderer fulfils the aggregated minimum requirement for economic and financial standing cf. section 2.2.1 and section 4. The tender is divided into the following lots, and the value of the contracts is expected to amount to: • Lot 1 - NEA: Expected value: EUR 42,550,000.00 • Lot 2 – NEA: Expected value: EUR 42,550,000.00 • Lot 3 – SLF02: Expected value: EUR 28,200,00.00 For further detail concerning the purchase, reference is made to the tender documents.

Procedure og udbudsmateriale

Oplysninger fra bekendtgørelsen kan dække flere delkontrakter. Listerne nedenfor er separate uddrag; rækkefølgen kobler ikke et kriterium til en beskrivelse eller delkontrakt. Kontrollér krav, vægtning, frister, optioner og eventuelle rettelser i originalmaterialet.

Proceduretype (kildens kode)

  • neg-w-call

Tildelingskriterier

  • Price
  • Technical Solution
  • Programme, organization and manpower
  • Contract terms

Beskrivelser af tildelingskriterier

  • When evaluating 'Price', the Contracting Authority will evaluate the Total Tender Price in the submitted Schedules of Prices.
  • The Contracting Authority will focus on the documentation provided by the tenderer who are encouraged to submit detailed and thorough responses as the below listed elements will be of particular importance in the evaluation: 1. System design: The quality of the engineering documentation (based on design documentation, calculations, values, and statements), including the extent to which this provides evidence that the system is fit for purpose according to the Technical Requirements. Further, the robustness of the solution including documentation and calculations supporting this will be favored. In this context it will be considered positive if the solution provides evidence of having very robust jackets, a high level of pulling force, and provide evidence of water-prof design of joints and link-boxes. 2. Installation, setup and testing: The quality of the plan for installation of accessories and plan for testing during installation. It will be evaluated positively that the documents are detailed, practical and provide evidence of a solution which will secure ease of execution of work on site. 3. Minimum allowed bending radius: The minimum allowed bending radius during installation and after installation (in final position at terminations) is equally evaluated. A larger bending radius is evaluated negatively. 4. Allowable roller pressure: Allowable roller pressure will be evaluated. A higher roller pressure will be evaluated positively. 5. Lay length of screen wires (if applicable): Concerning lay length of screen wires (in multiple of screen diameter), longer lay length will be evaluated negatively. 6. Electrical stress: As for electrical stress at the insulation screen (outer semiconducting layer), a lower electrical stress will be evaluated positively. 7. AC resistance: Will be evaluated based on a combination of the tenderers stated value and quality of available documentation to support this. A lower AC resistance will be evaluated positively. Higher similarity of tested conductor to offered will be evaluated positively. 8. Current rating: Both continuous and short term rating will be evaluated. A higher current rating will be evaluated positively. An overall evaluation will be made of this sub-criterion
  • The evaluation will be based on to which degree the tenderer demonstrates a well-planned, realistic, and robust time schedule/programme, which allows sufficient time for potential contingencies, but still provides evidence of a high level of security for delivery within the timeframe as set out. In this context it will be evaluated positive that: 1) the description and the Project Programme reflect a realistic, and frontloaded, programme for the critical activities including production and considerations for actions in case of unforeseen events (breakdown etc.). 2) the description and programme contain a robust production schedule including all tests, delivery time, robust planning for installation of joints and cable terminations, and supervision activities on site and the associated manpower. 3) the description demonstrates the tenderer’s ability to identify and overcome known risks in the production, transportation, and installation phases. 4) the description provides an operational organisation on site in Denmark, with clear roles, responsibilities, hierarchy and procedures for escalation. Further, interfaces are handled with clear lines for communication. 5) the ability to extent personnel on site in case of unforeseen delays concerning the jointing work is also covered by the description and ensures efficient execution at all time. An overall evaluation will be made of this sub-criterion.
  • The tendered assignment must be performed on the basis of the attached contract terms. Apart from the clauses and sub-clauses listed in section 3.7.1, which are not part of the evaluation of “Contract terms”, it is possible for the tenderer to make explicit and well-explained deviations. These will be included in the evaluation of the sub-criterion "Contract terms" and it is noted that any deviation(s) may lead to a reduction to the score depending on content, clarity, and consequence of the deviation. In this regard, it is explicitly noted that deviations which intends to limit liability and shift the financial risk in favour of the tenderer will be of particular importance in the evaluation. A minimum score of 4 must be achieved, cf. sub-section 3.7.1. If the tenderer has no deviations the evaluation of this sub-criterion will result in the maximum score of 10. An overall evaluation will be made of this sub-criterion.

Oplyste optioner

  • N/A

Aflevering af tilbud

Åbn originaludbud

Andre bekendtgørelser i samme CPV-kategori

Nyeste bekendtgørelser med samme firecifrede CPV-kategori. Listen kan omfatte både åbne udbud og historik.